All Things Mk5 > How to Guides / Troubleshooting
Parking Sensors OPS tutorial needed
SI-R32:
Good that gateway beens updated means it defo compatible with ops, if everything was fine before yesterday then it should be again, just go over everything you've done double checking it all
SI-R32:
Plus not to criticise but your solder joint has a massive sharp point on it have you insulated it properly and the other wire you have bared the copper of, you don't want these touching the car body or anything else by mistake
Rossimac:
Everything working perfectly before yesterday!
Looking at another picture from yesterday, I THINK I may have taken the wrong pin from the Gateway for CAN low.
I think I may have used Pin 5 and not Pin 6.
Look at the purple dots on - they look very similar to the dots in my "before" picture....
Compared to:
Hopefully this is the issue.
Rossimac:
--- Quote from: SI-R32 on November 29, 2015, 10:46:19 am ---Plus not to criticise but your solder joint has a massive sharp point on it have you insulated it properly and the other wire you have bared the copper of, you don't want these touching the car body or anything else by mistake
--- End quote ---
Critisice away :) Any suggestions are always welcome. Wasn't me personally that did the solder :P
Will get these taped up today.
SI-R32:
Well hopefully you haven't damaged anything, I'm sure you'll sort it todsy
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version