All Things Mk5 > How to Guides / Troubleshooting
Vcds scan results
Vwgtiking:
Need some help. This morning I had no errors but soon as I started the car this afternoon I had the engine mgt light on. Just done a scan. Can anyone help with the below faults pls?
Pls note it's a diesel bkd.
VCDS Version: Release 15.7.3 Running on Windows XP x86
Data version: 20151216
www.Ross-Tech.com
Wednesday,30,March,2016,17:55:37:07515
Chassis Type: 1K (1K0)
Scan: 01 03 08 09 15 16 17 19 25 42 44 46 52 56 62 72 7D
VIN: WVWZZZ1KZ7M035360 Mileage: 253190km-157324miles
-------------------------------------------------------------------------------
Address 01: Engine Labels: 03G-906-016-BKD.lbl
Part No SW: 03G 906 021 KK HW: 03G 906 021 KK
Component: R4 2,0L EDC G000SG 9970
Revision: --H02--- Serial number: VWZ7Z0F4157002
Coding: 0000072
Shop #: WSC 02856 128 00032
VCID: 72E12BBC6DB27AAE77-8026
5 Faults Found:
005685 - Powertrain Data Bus
P1635 - 000 - Missing Message from A/C Controller - Intermittent
Freeze Frame:
Fault Status: 00100000
Fault Priority: 3
Fault Frequency: 1
Reset counter: 255
Mileage: 252693 km
Time Indication: 0
Date: 2000.00.00
Time: 17:14:43
Freeze Frame:
RPM: 882 /min
Speed: 0.0 km/h
Load: 0.0 %
Voltage: 14.67 V
Bin. Bits: 00001100
Bin. Bits: 00000000
(no units): 0.0
005697 - Please check DTC Memory of A/C Controller
P1641 - 000 - - Intermittent
Freeze Frame:
Fault Status: 00100000
Fault Priority: 6
Fault Frequency: 1
Reset counter: 255
Mileage: 253146 km
Time Indication: 0
Date: 2000.00.00
Time: 18:24:04
Freeze Frame:
RPM: 0 /min
Speed: 0.0 km/h
Load: 0.0 %
Voltage: 11.70 V
Bin. Bits: 00001100
Temperature: 12.6°C
(no units): 16.0
012547 - Motor for Intake Manifold Flap (V157)
P3103 - 000 - Malfunction
Freeze Frame:
Fault Status: 01100000
Fault Priority: 2
Fault Frequency: 5
Reset counter: 255
Mileage: 253173 km
Time Indication: 0
Date: 2000.00.00
Time: 17:41:36
Freeze Frame:
RPM: 1806 /min
Speed: 45.0 km/h
Load: 33.3 %
Voltage: 14.52 V
Bin. Bits: 00001000
Torque: 280.6 Nm
Torque: 158.6 Nm
001681 - Fan 1 Control Circuit
P0691 - 000 - Short to GND
Freeze Frame:
Fault Status: 01100000
Fault Priority: 3
Fault Frequency: 1
Reset counter: 255
Mileage: 253173 km
Time Indication: 0
Date: 2000.00.00
Time: 17:41:40
Freeze Frame:
RPM: 1764 /min
Speed: 45.0 km/h
Load: 0.0 %
Voltage: 14.52 V
Bin. Bits: 00001000
Temperature: 85.5°C
Duty Cycle: 9.7 %
012545 - Motor for Intake Manifold Flap (V157)
P3101 - 000 - Open or Short to Ground - Intermittent
Freeze Frame:
Fault Status: 00100000
Fault Priority: 2
Fault Frequency: 1
Reset counter: 255
Mileage: 253183 km
Time Indication: 0
Date: 2000.00.00
Time: 17:03:16
Freeze Frame:
RPM: 1386 /min
Speed: 20.0 km/h
Load: 0.0 %
Voltage: 14.52 V
Bin. Bits: 00001100
Torque: 183.0 Nm
Torque: 0.0 Nm
Readiness: 1 1 0 0 0
Address 7D: Aux. Heat Labels: 1K0-963-235.lbl
Part No SW: 1K0 963 235 E HW: 1K0 963 235 E
Component: PTC-Element 0404
Revision: 00800000 Serial number:
Shop #: WSC 00000 000 00000
VCID: 2D5BF8C0B40C6556EA-8078
1 Fault Found:
00361 - Heater Element for Auxiliary Heater (Z35)
014 - Defective
End-------------------------(Elapsed Time: 01:58)--------------------------
Pls also not I changed the heater controls and have just noticed my old ones said climatic on them whereas my new ones don't. Would this make any difference?
to the ac error codes?
doylebros:
I would say the AC panel is causing most of your faults but the intake manifold flap is most likely a blown fuse possibly due to the above panel.
Vwgtiking:
Touchwood. It was the fuse in the engine bay f24, it had blown. Changed it and now doing another scan.
doylebros:
If the fan goes faulty it blows that fuse.
Vwgtiking:
All faults now gone apart from the aux heater. Any ideas on where the fuse is or test it somehow with vcds?
Navigation
[0] Message Index
[#] Next page
Go to full version