All Things Mk5 > Members Rides
Dubvrs 2008 GTI restoration and upgrade
Rippers:
Are they a straight fit? Looking forward to seeing them on
dubvrs:
--- Quote from: Rippers on July 19, 2016, 08:49:32 pm ---Are they a straight fit? Looking forward to seeing them on
--- End quote ---
Need a set of 15mm 5x112 to 5x120 PCD adapters for the wheels to fit but easily available.
ChrisGT:
Out of interest where did you source that r32 bumper with non r32 exhaust hole? Is it the one from Maxton design, been looking into getting one for my gt tdi.
Cheers,
Chris
gunnellgti:
Hi mate , looking for a way to mount my plate (other than the cable ties that im using now) where abouts did you source this bracket? Cheers, Sam
Number plate bracket turned up but paint was poor quality. Cameo off when you touched it so repainted.
May shorten it so it sits closer to the bumper but allows air into the open grille as it is.
Couple of more bits to do over the weekend.
[/quote]
dubvrs:
--- Quote from: gunnellgti on July 22, 2016, 05:28:33 pm ---Hi mate , looking for a way to mount my plate (other than the cable ties that im using now) where abouts did you source this bracket? Cheers, Sam
Number plate bracket turned up but paint was poor quality. Cameo off when you touched it so repainted.
May shorten it so it sits closer to the bumper but allows air into the open grille as it is.
Couple of more bits to do over the weekend.
--- End quote ---
[/quote]
I got it off eBay but I know the guy that was producing them does not make them anymore.
Had a trial fit of the rear bumper valance this afternoon. It does fit just not that great. Spent a bit of time adjusting on the top and got it to align up. Need to trim the arch liners down and adjust the lower bumper mounts.
Will have another go in the morning and also try the front splitter as it turned up this afternoon.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version