All Things Mk5 > How to Guides / Troubleshooting

Rear ABS loom?

(1/2) > >>

GVK:
Whilst fitting a rear ABS sensor I've managed (heavy handed) to snap the locking tab off the connector that goes onto the sensor  :slap:

Anyone know if there is a repair loom for these, cost of and how far does it go into the car?

terrier:
The broken piece will have a part number on it. Simple splice should do it. Like me you may need a magnifier to ID

Octoparrot:
You can buy new connectors from vw or on ebay and replace it by de pinning the connector, there are some videos on YouTube.

GVK:
Found this on ECS tuning.

https://www.ecstuning.com/b-genuine-volkswagen-audi-parts/rear-abs-sensor-wiring-harness-right/1k0927904aj/

right rear 1K0927904AJ will see if it's available from VW in UK.

LC5F:
Replacing that section of loom is likely to be a right faff.

I would go for replacement connector as suggested by Terrier & Octoparrot
The rubber boot will peel back and you just need to remove the pins and reassemble onto the replacement connector.
Personally I would be happy with a scrap yard sourced used connector, in fact grab a couple

Navigation

[0] Message Index

[#] Next page