All Things Mk5 > Mk5 General Area

ABS fault (01130) and module replacement

(1/1)

Nertballs:
Hi all,

So I've gotten the 01130 fault code and accompanying christmas tree dash board. I checked all the fuses (all okay) so I'm going to have to change the pump/module.

My car (mk5 GT TDI 140 DSG) has the 1K0 614 517 BE pump, and I've been tearing my hair out trying to find a replacement that isn't crazy money. Are there any other versions that will drop in? I have VCDS so can do the coding side, just making sure I'm getting the right pump is the main concern.

Thanks in advance!

bobby_fodge:
It's definately not the wheel speed sensors?

Nertballs:
No codes were coming up for a specific wheel sensor, just 01130, then 008 - plausibility fault.

Nertballs:
I've managed to get a hold of an almost identical pump/module:

1K0 614 517 BG

Anyone know if there's any different wiring connections I should be aware of? I've looked up but can't find any details. I know I'll need to do the long coding but just wondering if there's anything else to keep an eye out for.

Nertballs:
Just an update to this in case anyone is chasing down a replacement pump, I fitted the BG pump today and got it working fine.

Straight swap on the units themselves, no issues with connectors. I had copied my coding from my previous pump before removal. When I connected to the new pump I was getting the DTC "Incorrect Control Module", so I went into the long coding section, turned off hill hold (new pump didn't have it) and cleared the code, all good.

After the coding I did all the required adaptions, and did the vagcom brake bleed. The dash lights don't go off until you drive the car, so got that done and I now have ABS again after 4 months! Just need to get through the NCT now.

Would've liked to keep Hill Hold, but was struggling to get the right pump so a working replacement unit in for 100 quid and I'm happy enough.

Navigation

[0] Message Index