General > Shows, Events and Meets
Rolling Road Meet @ JKM - Oct 16th - Provisional....
chungster:
--- Quote from: chrishalfpenny on September 13, 2010, 08:23:27 pm ---could i bring my r32 down for a run?
--- End quote ---
its a 2WD set up they have unfortunately.
you could run it in that mode of course with fuse pulled.
chrishalfpenny:
yeah thats what i meant i was under the impression that the best way to run them was in 2wd anyway as the haldex messes with the results
Hedge:
--- Quote from: chrishalfpenny on September 13, 2010, 08:49:59 pm ---yeah thats what i meant i was under the impression that the best way to run them was in 2wd anyway as the haldex messes with the results
--- End quote ---
I know where you read that and its a load of tosh :smiley:
By all means run on JKM's Dyno in 2WD but I bet you get the same results at Surrey Rolling Road. :wink:
Saint Steve:
--- Quote from: chrishalfpenny on September 13, 2010, 08:49:59 pm ---yeah thats what i meant i was under the impression that the best way to run them was in 2wd anyway as the haldex messes with the results
--- End quote ---
Be good to see you their Chris. They will run your R32, normally after they have finished running the front wheel drive cars 1st. :happy2:
Hedge:
--- Quote from: Saint Steve on September 14, 2010, 08:04:11 am ---
--- Quote from: chrishalfpenny on September 13, 2010, 08:49:59 pm ---yeah thats what i meant i was under the impression that the best way to run them was in 2wd anyway as the haldex messes with the results
--- End quote ---
Be good to see you their Chris. They will run your R32, normally after they have finished running the front wheel drive cars 1st. :happy2:
--- End quote ---
Run it normally? Don't think so.
To run at JKM you need to pull the Haldex fuse but the results will be the same as from SRR or any other reliable 4WD dyno. :confused:
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version