All Things Mk5 > How to Guides / Troubleshooting
Threaded bolt head removal....
u01atc8:
Ok so a little bit of help needed!
I tried to remove my back seats and the bolt for the larger back section seatbelt is threaded already do obviously someone has had a gonat one Yupik a time before I bought it. So anyway how will I remove it! It's the one if your in th boot on the right hand side screwed into the bottom if the car. I was going to drill through it but was worried that I would hit the fuel tank or something! Then I would get fright! :jumping:
vRStu:
Brute force I would think, it's been screwed in wrongly so it'll normally come back out. It'll probably not go back on without running a tap down it first. Much better solution than drilling out if you can manage it.
vRStu:
Just had another thought -
These do pass through to the bottom of the car IIRC, so it may just be covered in sh*te under the car which is stopping it coming back through. If you can locate the underside of it and soak a load of WD40 onto it that may help.
uk_stu:
http://shop.ebay.co.uk/?_from=R40&_trksid=p3907.m570.l1313&_nkw=easy+outs&_sacat=See-All-Categories
Drill a pilot hole then begin to wind the reverse thread easy out down it then hey presto!
vRStu:
--- Quote from: uk_stu on September 22, 2010, 10:18:35 am ---http://shop.ebay.co.uk/?_from=R40&_trksid=p3907.m570.l1313&_nkw=easy+outs&_sacat=See-All-Categories
Drill a pilot hole then begin to wind the reverse thread easy out down it then hey presto!
--- End quote ---
Only really required if the head on the fixing is destroyed.
Navigation
[0] Message Index
[#] Next page
Go to full version