All Things Mk5 > Members Rides

Eddy goes on a diet (few updates)

<< < (18/65) > >>

NeilM:
Yeh I like the Stainless Steel finish against the Carbon  :happy2:

gazbutS3:

--- Quote from: NeilM on December 01, 2010, 05:50:21 pm ---I'm pretty much snowed in, but I've got this to play with  :happy2:





Going to template and cut the panels in the rear, looking at fixings but only 1mm thick so countersinking is a bit tricky.



--- End quote ---

Lookin good Neil, we use a thing called a tinamun(think thats spelt correctly :smiley:) washer on the aircraft when its a thin skin to allow countersinking and can also allow for a bit of adjustment, I'll try and get a picture of said item 2 morra if you like :happy2:

damoegan:
You must use stainless fittings on carbon, its the law  :chicken:

Just looks soooo gooood  :happy2:

NeilM:

--- Quote from: gazbutS3 on December 01, 2010, 08:21:52 pm ---Lookin good Neil, we use a thing called a tinamun(think thats spelt correctly :smiley:) washer on the aircraft when its a thin skin to allow countersinking and can also allow for a bit of adjustment, I'll try and get a picture of said item 2 morra if you like :happy2:

--- End quote ---

Cheers gaz, be nice to get the fixings flush.  :happy2:

gazbutS3:
there you go Neil, not the best picture but i hope you get the idea, they can be had in various materials and sizes :happy2:



you drill the hole slightly bigger than the underside csk, and sometimes give the component that your mounting to a slight csk, depending on material thickness. Hope that makes sense, probably make more sense when you have 1 of the washers in your hand :happy2:

I'm sure I can get you some if you require :happy2:

Navigation

[0] Message Index

[#] Next page

[*] Previous page