All Things Mk5 > How to Guides / Troubleshooting
19"- 8.5j - ET48 - 30mm drop?
danishmkvgti:
--- Quote from: apollo13 on January 03, 2011, 02:06:09 pm ---I'm not going to complain about you showing them Jake :signLOL:
Have you had yours trial fitted mate?
It would help me out if you knew the measurement from the floor to edge of wheel arch, centre of the wheel front and rear?
:drinking:
Lee.
--- End quote ---
Front floor to edge of wheel arch = 620mm
Rear floor to edge of wheel arch = 654mm
Front center to edge of wheelarch = 314mm
Rear center to edge of wheelarch = 328mm
:drinking:
apollo13:
--- Quote from: danishmkvgti on January 04, 2011, 01:05:55 pm ---
--- Quote from: apollo13 on January 03, 2011, 02:06:09 pm ---I'm not going to complain about you showing them Jake :signLOL:
Have you had yours trial fitted mate?
It would help me out if you knew the measurement from the floor to edge of wheel arch, centre of the wheel front and rear?
:drinking:
Lee.
--- End quote ---
Front floor to edge of wheel arch = 620mm
Rear floor to edge of wheel arch = 654mm
Front center to edge of wheelarch = 314mm
Rear center to edge of wheelarch = 328mm
:drinking:
--- End quote ---
Thanks Jake, your a gent :drinking:
I'll get my tape measure out....
Dario:
--- Quote from: apollo13 on January 04, 2011, 11:47:53 am ---
Hmmm...45mm Whats the rubbing like Dario?
--- End quote ---
rubbing NO at this drop ,but on 65mm drop little bit :happy2:
apollo13:
--- Quote from: Dario on January 04, 2011, 06:43:39 pm ---
--- Quote from: apollo13 on January 04, 2011, 11:47:53 am ---
Hmmm...45mm Whats the rubbing like Dario?
--- End quote ---
rubbing NO at this drop ,but on 65mm drop little bit :happy2:
--- End quote ---
65mm :grin: I'm not surprised!! Not many speed bumps near you then??............. :signLOL:
Dario:
65mm is all way down on KWs and its ok for normal drive ,speedbump :sick: ,you just find another route :jumping:
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version