All Things Mk5 > Members Rides
Sunset Red 1.4 TSI(TFSI) GT Sport - daily drive & track car
the bruce:
Rex, will the filter enclosure remain open?
Then it'l suck hot air !! :wink:
ps: wish I could reach the brake fluid as easy as you
rex:
Well, with the open filter is a longer story... But you definitely have a good point!
I have a pipe that goes to the open front RLine grille. This is for the cold air intake. This pipe is installed but not visible in the photos.
The filter has TUV, only with the top on but they say that if I want more power just take the top off...
While testing the car it seemed that I have more power with the open air filter (sightly more boost). So I guess I will go with the open air filter.
the bruce:
--- Quote from: rex on October 05, 2011, 09:05:57 am ---I am thinking of changing my track wheels and I would like to buy Team Dynamics Pro Race 1.2 7.5 x 17 ET 45.
Does anybody know if this wheels fits the nqsbbk without the use of spacers? Please note than the wheel I want to buy is only 7,5 inches wide and 17 inches in diameter (opposed to the 8x18 ET45 rim used by many over here).
--- End quote ---
Unfortunately I can't answer your question, but I have my own question
for you: Why change the wheels? Of course they will be a bit lighter, but
is it worth the hassle?
And if you change the wheels why not swap to a non compromise solution?
8" width and an offset of ET50 seem much more perfect to me.
Tfsi_Mike:
Great thread Rex :congrats:
Top Cat:
--- Quote from: rex on October 05, 2011, 09:05:57 am ---I am thinking of changing my track wheels and I would like to buy Team Dynamics Pro Race 1.2 7.5 x 17 ET 45.
Does anybody know if this wheels fits the nqsbbk without the use of spacers? Please note than the wheel I want to buy is only 7,5 inches wide and 17 inches in diameter (opposed to the 8x18 ET45 rim used by many over here).
--- End quote ---
I am going to guess at yes, they should fit. I had the same spec track wheels and fitted the B5 RS4 set up under a 17in TD at 7.5 width the disc was 362 mil. It is the diameter of the wheel that needs checking for clearance. i had to put the wheel balance weights on the back of the rim, because of the tiny clearance.
And i think you will be using smaller discs so i cant see why it wouldn't fit. ( though i could easily be talking through my arse. ) :rolleye:
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version