General > Detailing

stone chips

(1/2) > >>

matsu:
just a quicki
if i fill in and then want to smooth them down a little with ultr fine wet and dry... what the best thing to hand buff the whole area afterwards please

thanks
matsu

alexperkins:
Autoglym SRP is pretty good for this

If you have access to a DA, a machine polished finish will be far superior.

matsu:
thanks mate
 i have that.
 i also have poorboys ssr1 swirl remover....if thats any better
 and an old tube of red t cut if that will get job done lol- (my dad old car was red)

will be done by hand- havent got a machine or the nerve to trial one out yet
matsu

alexperkins:
SSR1 carefully applied by hand should work :)

Just be sure to give it a good coat of sealant/wax after you are finished

And to use plenty of soapy water with the wet'n'dry

SimonBash:
If you can avoid wet-sanding, I would apply several very thing layers of touch-up to the chip over a week or so, if you are careful no wet-sanding or polishing will be required.

Navigation

[0] Message Index

[#] Next page