All Things Mk5 > Performance Modifications

Paramount Performance - Slough - REMAP GROUP DISCOUNT

<< < (2/3) > >>

johnhol78:

--- Quote from: PDT on April 06, 2011, 06:11:42 pm ---37 degree temperatures at the front of the car?  The AT and IT should be pretty close ideally. Nice smooth graph though.

--- End quote ---

It was baking there so they used the thermometer part of the Dyno to read the temp going into the intake.....Dyno though the air was colder than actually going in so was coming up at 233bhp then when the correct temp was read....it went up to this.

johnhol78:
They were lmost blowing warm air into it....bloody boiling out there today.  :grin:

Janner_Sy:
very good spread of power there from 5-7k.  Torque isnt the highest, but still 250lbft is very good amount of torque and will preserve the clutch

johnhol78:

--- Quote from: Janner_Sy on April 06, 2011, 06:18:17 pm ---very good spread of power there from 5-7k.  Torque isnt the highest, but still 250lbft is very good amount of torque and will preserve the clutch

--- End quote ---

Thanks, that's what they said, They'd rather give a safe map on a standard car than give me more than I need and the car can handle..

They're looking at Stage2 and up on there TT TFSi and going to keep me informed on what they find out.

They want to try and push the boundaries to see what a standard car can do without any mods and then move on from there.

They did say I might benefit from either a CAI or Induction.....would prefer a CAI tbh as inductions are too noisy for me. Opinions?

PDT:
Here comes tnat slippery slope  :grin:

Navigation

[0] Message Index

[#] Next page

[*] Previous page