All Things Mk5 > Members Rides
G14OSE - Mk5 Jetta Project - 25/07/11
MitchGTI:
does that not effect anything else by cutting a piece out? ollie are you all the way down o your coil's? with no rubbing?
OLLIE_JETTA_MK5:
yeh ! all the way down ... doesnt rub apart from the poke from them merc wheels when you hit a little bump etc ?
thought mine was low enough till i saw this one haha
Conrad The Jellyfish:
--- Quote from: OLLIE_JETTA_MK5 on September 22, 2011, 06:56:30 pm ---yeh ! all the way down ... doesnt rub apart from the poke from them merc wheels when you hit a little bump etc ?
thought mine was low enough till i saw this one haha
--- End quote ---
cheers dude, hopefully going to get ti even lower, going to lower the rear a little more next week too :) Think Ive got the offsets nailed pretty well, good balance between tuck and poke, just about right on the arch :) so i can go dick lows
Mitch - I Have 6mm tubed steel welded in so should be even stronger than the chassis legs was before tbh.
JoeDarKa:
Which coilovers are you using? How much did they set you back? Cheers
stevw1:
Couple of Q's regarding wheel specs:-
1. Were you scrubbing when the fronts had the 10mm spacer on ? ET49 iirc with an 8.5j rim
2. Whats the current spec on the rears 9.5j ET and spacer ??
Wanting to see if i can tuck a 10j with a high offset :scared:
Cheers Steve
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version