All Things Mk5 > Revo Zone
Revo settings - SPS Switch - Confused
Kiwi:
Right so first off the car:- Edition 30, TBE, ITG and thats it (so far)
Currently mapped on a Stage 2, and then a Stage 1 DSG ( Beautiful, amazing car now )
So due to work (long story) I mostly run the car on 95Ron, so I was mapped for this (Stage 2 Settings) 7B, 3T, 9F
Now I do have a SPS switch, which I would like to setup fully, the idea I'd like to do is have the Settings for 95Ron, but also have (a safe setting) for 98/99 Ron.
Looking through the search here, I find a few different settings, not sure what would be best to use?? So far I have seen 6B, 5T, 9F, also 6B, 3T, 9B both for 98Ron.
So is there a setting I should consider or have missed? is there any damage I could do, by using either of them.
As a newbie to Remapping, it would be far easy if there was a matrix on the site in excel form, showing what basic settings should be used.
Anyway any help welcome
Kiwi
Poppa Dom:
You need to be careful on this as there will be a difference in settings if your base map is optimised for running on 95ron, or am I reading it wrong and that you have a generic base map that is optimised for 95 Ron via sps settings?
For a preliminary base setting for 98ron I would go b7t4f9. But I would strongly encourage some live logging with vcds to ensure that optimal settings are achieved.
HTH
Kiwi:
--- Quote from: DomT on June 27, 2011, 06:36:11 pm ---You need to be careful on this as there will be a difference in settings if your base map is optimised for running on 95ron, or am I reading it wrong and that you have a generic base map that is optimised for 95 Ron via sps settings?
For a preliminary base setting for 98ron I would go b7t4f9. But I would strongly encourage some live logging with vcds to ensure that optimal settings are achieved.
HTH
--- End quote ---
Based map set for 95Ron, Thanks for your input :happy2:
JackG:
Can someone post a picture of one of these SPS units?
I'm confused about what they actually are :ashamed:
Are they pre loaded or do you have to have the car set up and the files stored on the sps switch?
Does it allways have to be plugged in or can you just change the file setting and unplug it?
Can you have stage 2+ files on it? Why would you want to change the settings?
Cheers guys :happy2:
Tfsi_Mike:
--- Quote from: JackG on September 04, 2011, 05:05:33 pm ---Can someone post a picture of one of these SPS units?
I'm confused about what they actually are :ashamed:
Are they pre loaded or do you have to have the car set up and the files stored on the sps switch?
Does it allways have to be plugged in or can you just change the file setting and unplug it?
Can you have stage 2+ files on it? Why would you want to change the settings?
Cheers guys :happy2:
--- End quote ---
You may want to run more conservative safer settings, you may want to adjust to run better with different grades of fuel, you may change / upgrade hardware on your car and adjust mapping to suit for best performance or reliability.
You make the settings with the software and transfer the settings to the car with the SPS unit :happy2:
Navigation
[0] Message Index
[#] Next page
Go to full version