All Things Mk5 > Members Rides
Tfsi Mikes Money Pit :: AKS built Cupra :: TTE420 :: Rtech Tuned
rich83:
TT Roadsport have done my last 2 cars, very happy with the service.
vRSAlex:
--- Quote from: richwig83 on December 30, 2011, 11:10:36 pm ---TT Roadsport have done my last 2 cars, very happy with the service.
--- End quote ---
You missed the bit saying Alex at BDM knows the most about this setup and would be the best person to use for setting your car up perfectly?!
:signLOL:
rich83:
--- Quote from: BDMAlex on December 30, 2011, 11:27:11 pm ---
--- Quote from: richwig83 on December 30, 2011, 11:10:36 pm ---TT Roadsport have done my last 2 cars, very happy with the service.
--- End quote ---
You missed the bit saying Alex at BDM knows the most about this setup and would be the best person to use for setting your car up perfectly?!
:signLOL:
--- End quote ---
:signLOL:
Id come up at the same time as mikey boy, but i can't afford it at the moment. :sad1:
Tfsi_Mike:
Quite a disappointment today. Drove down to Northampton to BDM for fast road setup after having the TT lower arms fitted.
Driving away the car's barely driveable as the wing (near where it meets my bumper) is shedding the tyre over slight bumps and bends. :sick:
BDM Alex & myself were hoping Alex would be doing the alignment as he's very familiar with the chassis but the bosses had other things planned for him. :sad1:
Admittedly the NSF arb clamp is snapped which doesn't help by any stretch but it wasn't as near as bad on the drive down.
I would've preferred to have been there when the initial measurements were taken and discussed what needed to e done.
I'm going to raise the car up 1st chance I get 10-15mm all round in hope it solves it, will have to get alignment re checked after.
Alex regapped the plugs and changed my brake fluid and the car feels a lot better for both so a big thanks to him for that! :happy2: :drinking:
Quite frustrated and a few hundred quid lighter :sick:
rich83:
:confused:
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version