All Things Mk5 > Performance Modifications
fitting cat back milltek exhaust
vRS_Pagey:
Yeah, clamps are definitely good quality, the ones supplied with mine are like this -
They do the job but I will be replacing them with the type you have, tbh I think the whole set up is a tad on the expensive side, having said that the quality will be top notch from Milltek, although I'm a bit confused why both ends haven't got splits in them? Without them the clamp is unlikely to compress the pipe enough to hold it tight. :confused:
Just waiting for the fitted pictures and sound bite........ :popcornsoda:
jedi-knight83:
one end on mine goes inside the split end on the end of my centre pipe...hence only one end on the adapter is split
vRS_Pagey:
--- Quote from: jedi-knight83 on October 12, 2011, 06:03:30 pm ---one end on mine goes inside the split end on the end of my centre pipe...hence only one end on the adapter is split
--- End quote ---
So there is a split end on the Milltek part of the exhaust? Both the joining ends I have are solid pipe so I presume that if I contact Milltek and explain my requirements then the pipe I receive will have splits on both ends, with that in mind I think perhaps the 24 quid is actually worth it. :happy2:
Cheers buddy.
jedi-knight83:
yes... i didnt actually tell them thats how my exhaust was... i actually thought all exhausts would fit like that so maybe i've been lucky or maybe thats the only one milltek do?
vRS_Pagey:
--- Quote from: jedi-knight83 on October 12, 2011, 06:34:31 pm ---yes... i didnt actually tell them thats how my exhaust was... i actually thought all exhausts would fit like that so maybe i've been lucky or maybe thats the only one milltek do?
--- End quote ---
At a guess they will know the make up of exhaust components, but I will bare that in mind when I ring them tomorrow. :smiley:
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version