General > Shows, Events and Meets
JKM Rolling Road - 11th February 2012....
GarethB:
Got a few pics, but may be a tad slow on the upload as my internet is terribly slow today :confused:
Here is myself and Nodz guarding the bourbons....
GarethB:
Something isn't quite sitting right when Ryan's car is on the dyno
Subframe bolt touching the rollers :evilgrin:
vRSAlex:
--- Quote from: alackofspeed on February 11, 2012, 03:42:25 pm ---
--- Quote from: Janner_Sy on February 11, 2012, 03:04:33 pm ---Whsts your spec
--- End quote ---
K03 DSG Revo Stg-1, b8t5f9
--- Quote from: heavyd on February 11, 2012, 03:24:16 pm ---
:surprised:
Thought you had the super dooper new Revo stage 2+ :stupid:
--- End quote ---
Nope - just stg1, set as above.
Jim (?) suggested wastegate issues, and that I should check for a crack in the turbo housing near the wastegate. He also said he'd bet that if I logged boost target versus actual there would be discrepancy. I've checked and there isn't, and the N75 isn't ever hitting 100% except when spooling at low revs, so I don't think there is a wastegate problem.
e.g:
revs requested actual
5400 1950 1920
5600 1890 1870
5840 1810 1830
6040 1730 1790
6240 1710 1740
6400 1720 1710
6560 1700 1700
6680 1050 1680
The car drives fine, so I'm inclined to ignore the dyno figures. Hell they theoretically make my insurance cheaper! :grin:
As a slight aside, I logged the g/s whilst on the dyno, and the car was consuming about 20g/s less than it does on the road.
--- End quote ---
Can you get a full log of actual vs requested?
Tfsi_Mike:
--- Quote from: GarethB on February 11, 2012, 04:08:12 pm ---Something isn't quite sitting right when Ryan's car is on the dyno
Subframe bolt touching the rollers :evilgrin:
--- End quote ---
Nearly low enough Ry :grin:
Nodz:
--- Quote from: GarethB on February 11, 2012, 04:03:51 pm ---Got a few pics, but may be a tad slow on the upload as my internet is terribly slow today :confused:
Here is myself and Nodz guarding the bourbons....
http://i422.photobucket.com/albums/pp302/garethbridgland/IMG_3125-1.jpg
--- End quote ---
I don't think we done a very good job lol
--- Quote from: Tfsi_Mike on February 11, 2012, 04:18:51 pm ---
--- Quote from: GarethB on February 11, 2012, 04:08:12 pm ---Something isn't quite sitting right when Ryan's car is on the dyno
http://i422.photobucket.com/albums/pp302/garethbridgland/IMG_3129.jpg
Subframe bolt touching the rollers :evilgrin:
--- End quote ---
Nearly low enough Ry :grin:
--- End quote ---
They tried jacking up the rollers but in the end he had to raise the suspension
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version