All Things Mk5 > Performance Modifications
BWA 370bhp+ What is needed?
R-tech-Nick:
--- Quote from: bacillus on January 31, 2012, 04:10:22 pm ---
--- Quote from: R-tech-Nick on January 31, 2012, 02:56:44 pm ---
--- Quote from: GrayMK5GTI on January 31, 2012, 11:55:51 am ---The R-Tech lads have a K04 equipped BWA pushing out 370bhp - they recon the engine does it no problems!
--- End quote ---
374bhp with WMI :wink:
--- End quote ---
Could you post the pre and post WMI dyno graphs?
--- End quote ---
WMI makes no power on its own merits it need to be mapped in to get nice gains , its used for efficiency to run a leaner AFR, strong advance tables and higher substained boost.
R-tech-Nick:
--- Quote from: ktlstar on January 31, 2012, 03:25:30 pm ---Nick, whats the fitting cost for water meth on a ed30 ? I will supply the kit, but what do you recommend ?
--- End quote ---
It not what we do, with James mk5 I was helping him out so we could get some mapping R&D time on the dyno with WMI.
18/19psi to the red @134bar rail pressure with WMI 18-21deg advance is the way forward..... :driver: It would be if I can get rid of this stupid EPC fault.... :ashamed:
bacillus:
--- Quote from: R-tech-Nick on January 31, 2012, 07:10:49 pm ---WMI makes no power on its own merits it need to be mapped in to get nice gains , its used for efficiency to run a leaner AFR, strong advance tables and higher substained boost.
--- End quote ---
I meant an overlay graph from when you originally mapped the k04 to results after wmi installed. :smiley:
danishmkvgti:
--- Quote from: james on January 31, 2012, 06:46:12 pm ---i have got a mk5 GTI with a BWA(with ko4) engine. I brought a S3 ecu from ebay as i was going to install a BHZ engine.
I wentt down the local scrappy and they offerd me this engine for 1.4k with gearbox but with no loom or ecu.
The engine was from a Golf R20
can i use my BWA loom?
--- End quote ---
I can't see why not, I have an BWJ (Cupra engine) with AXX loom and AXX ECU. :happy2:
james:
--- Quote from: danishmkvgti on January 31, 2012, 08:08:56 pm ---
--- Quote from: james on January 31, 2012, 06:46:12 pm ---i have got a mk5 GTI with a BWA(with ko4) engine. I brought a S3 ecu from ebay as i was going to install a BHZ engine.
I wentt down the local scrappy and they offerd me this engine for 1.4k with gearbox but with no loom or ecu.
The engine was from a Golf R20
can i use my BWA loom?
--- End quote ---
I can't see why not, I have an BWJ (Cupra engine) with AXX loom and AXX ECU. :happy2:
--- End quote ---
You still running the GTI map sensor then? 1.5Bar limit? as when i put the S3 map sensor in i just get fault codes.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version