General > Detailing

Opinions on Zymol

(1/4) > >>

Msportman:
Hi

Been using Glasure wax from Zymol for some time having used their normal carbon wax kits.

What do others think of Zymol?

I've always thought it gives a nice result but not knowing much about detailing I was wondering how it compares with other products.

Ian

autoperfection.com:
Hi Ian,

Zymol waxes are good waxes, however, they're very hard to use compared to other waxes in our experience and there are waxes out there that can achieve the same results and are easier to use, for less money.

Having said that, Zymol, like Swissvax, are at the top of their game and are one of the longest standing manufacturers.

Just our opinion  :smiley:

Taryn and Jim :happy2:

Msportman:

--- Quote from: autoperfection.com on May 05, 2009, 10:16:50 am ---Hi Ian,

Zymol waxes are good waxes, however, they're very hard to use compared to other waxes in our experience and there are waxes out there that can achieve the same results and are easier to use, for less money.

Having said that, Zymol, like Swissvax, are at the top of their game and are one of the longest standing manufacturers.

Just our opinion  :smiley:

Taryn and Jim :happy2:


Thanks

In what respect do you mean they are hard to use?

Do you think they resist stone chips on the front end and do you recommend a best approach to apllication of Zymol?

I have pre waxed and applied several coats but it can smear if you put a load on....I'm trying to sop the chips on my black paintwork.

Ian 

--- End quote ---

autoperfection.com:
We've found that they're sometimes harder to apply and buff off compared to other waxes we've experienced.

I don't think there is any wax out there that will resist stone chips, and with regards to application of Zymol - we've found it best to work on a panel at a time, leaving the wax for a couple of minutes and then buffing off.  This may not work the best for everyone, but we have found this to work well for us when using Zymol.

The smearing is caused by the oils and solvents in the wax not having enough time to evaporate properly if you apply it too thickly.  This can be minimised by applying a much thinner layer and allowing more time between coats.

As previously mentioned, whilst the wax will offer a high level of protection against the elements, we don't know of any wax that will stop stone chips - to prevent these you'd probably have to look at some sort of paint sheild.

 :happy2:

Msportman:
I found using Zymol on my previous MKIV from nearly new protected the front end reasonably well especially the bonnet.
Being black I wonder whether it is possible to have a black primar applied before painting?

I suppose my lower splitter will need re painting every so often.

On the wheel front my Pescara's were in need of attention. I initially used Wonder Wheels....it is OK but I've had to use Autosol on some stuborn areas. Any recommendations on this front?

I have given them a brief spray of Autoglym wheel wax.

Ian

Navigation

[0] Message Index

[#] Next page