All Things Mk5 > Performance Modifications
What upgraded HPFP are you running
Hurdy:
I'd be interested in that info Alex. :happy2:
anorganix:
--- Quote ---Had a bad experience with KMD so will never use them again. They all seized.
--- End quote ---
Agreed, I've seen 2 cases with failed KMDs.
danishmkvgti:
--- Quote from: vRSAlex on October 15, 2013, 11:23:21 pm ---If I was to buy one for my car again then iI would be loba every time. Currently running an APR with no issues. After fitting loads of loba pumps I believe they only just out perform the APR in terms of pressure response, build and hold.
Autotech pumps for me are a no go. Can blow seals although it's never happened to me. Very slow at pressure build too. They don't hold consistent pressure either.
Had a bad experience with KMD so will never use them again. They all seized.
Both the loba and apr can support over 150 bar of pressure too.
Off topic a bit, but I've had some info showing that S3 injectors flow more upto 7.5k than rs4 injectors and S3 injectors spray correctly.
--- End quote ---
If the pumps can deliver up to 150bar wouldn't it be helping the S3 injectors flowing more at the same opening time?
The info on the S3 injectors would you care to tell us more about that Alex? :)
nicky:
When fitting a new autotech can u replace the seals to help them stop blowing?? Or can u not buy this part separately.
Wooosh:
Running Autotech HPFP I'd recommend to others upgrading.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version