All Things Mk5 > Performance Modifications

Which Air Intake Position is best?....

<< < (5/6) > >>

Keith@APR:

--- Quote from: RedRobin on September 21, 2009, 11:05:41 pm ---^^^^
@ KeithAPR : -

Yes, Mk5 chassis. I didn't photograph all of them but you can see the floor matting through the gaps and this would normally be covered in on an oem GTI.





Quite a few race Mk5's were using an enclosed cone filter in the oem ram location but had the oem engine cover on - :confused: ?? Methinks that's a very nice and functional looking cone filter.

Notice the abundant use of plastic ties! :grin:


--- End quote ---

So where is the outside air entering the intake system from?  Air does not flow up from the ground to the top of the engine bay.

RedRobin:

--- Quote from: Keith@APR on September 29, 2009, 05:17:11 pm ---
So where is the outside air entering the intake system from?  Air does not flow up from the ground to the top of the engine bay.


--- End quote ---

....In most cases from the oem position - Upper grill. In a few cases via ducted air from the foglight aperture.

Keith@APR:

--- Quote from: RedRobin on September 29, 2009, 07:10:51 pm ---
--- Quote from: Keith@APR on September 29, 2009, 05:17:11 pm ---
So where is the outside air entering the intake system from?  Air does not flow up from the ground to the top of the engine bay.


--- End quote ---

....In most cases from the oem position - Upper grill. In a few cases via ducted air from the foglight aperture.

--- End quote ---

I would not consider that ideal.  Put it back directly in front of the grille opening and don't worry about any air from the lower bumper area.

bacillus:

--- Quote from: Keith@APR on October 13, 2009, 11:36:25 pm ---[I would not consider that ideal.  Put it back directly in front of the grille opening and don't worry about any air from the lower bumper area.

--- End quote ---

 I thought that Forge found that with the extra side intake on their twintertake they saw 3-4hp improvement vs just collecting air from the oem scoop??

RedRobin:
....

Have Forge released any concrete evidence of their Twintake's performance yet?

Or, even better, any independent evidence anywhere?

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version