All Things Mk5 > Mk5 General Area

MMMMM......Bilsteins!

(1/4) > >>

Hurdy:
A present arrived this morning....My Bilstein B16 PSS10's


Pic of simple damping adjustment setting for fronts

and same for the rears

Look where they tested during development  :innocent:


Roll on Wednesday and fitment with the TT wishbones :notworthy:

Anyone know where I can get these fully corner weighted?

gazbutS3:
They look lovely John, very trick adjusters,  :congrats:
I think a good coat of something needs putting on them adjusters before the winter eats them though :smiley:

Hurdy:

--- Quote from: gazbutS3 on September 18, 2009, 11:35:40 am ---They look lovely John, very trick adjusters,  :congrats:
I think a good coat of something needs putting on them adjusters before the winter eats them though :smiley:

--- End quote ---

Thanks for the tip Gaz. I wondered about corrosion resistance. The body is fine but the anodised bits could be susceptable over time.

gazbutS3:

--- Quote from: Hurdy on September 18, 2009, 11:39:23 am ---
--- Quote from: gazbutS3 on September 18, 2009, 11:35:40 am ---They look lovely John, very trick adjusters,  :congrats:
I think a good coat of something needs putting on them adjusters before the winter eats them though :smiley:

--- End quote ---

Thanks for the tip Gaz. I wondered about corrosion resistance. The body is fine but the anodised bits could be susceptable over time.

--- End quote ---

Yes, just a coat of vaseline or similar would help, you could clean off when adjusting then re-apply

VC:
om nom nom nom  :party:

Navigation

[0] Message Index

[#] Next page