General > Detailing

Removing the green mould from the window seals.

(1/4) > >>

Mk5Dom:
Can anyone recommend a good product to remove/reduce this?



I know it's for internal use but I have some ValetPro Enzyme Odour Eater in the workshop which I'm led to believe has the capabilities to remove mould. Will this work?   


Sent from my iPhone using Tapatalk

monte:
An old toothbrush with some APC will do the trick  :happy2:

It's good practice to go over all the rubbers with a detailing brush and APC before the sno-foam stage if you are doing an intensive wash.

If you are just doing a regular wash try to get into the habit of brushing over all the rubbers, grill, lights, fogs, glass, mirrors, door shuts, petrol cap, etc, etc using the sno-foam.

Just spray on the foam, leave it to dwell for 5mins, and then go round with the detail brush on the parts I listed above.
Then rinse.  :wink:

These are the type of brushes for the job...

http://www.polishedbliss.co.uk/acatalog/raceglaze-detailing-brush-set-cat25.html

stealthwolf:
I do the same with my car. Except I snowfoam first and then pretty much immediately go round with a brush as above. Every crease line, panel gap etc.

scopes:
A power washer in around that area will also help remove the mold...  :sick:

Mk5Dom:
Thanks for your replies chaps. I will use a detailing brush to agitate I guess.


Sent from my iPhone using Tapatalk

Navigation

[0] Message Index

[#] Next page