All Things Mk5 > Sat Nav and Car Audio

RNS 510 Installed but......

<< < (6/6)

ollie288:

--- Quote from: monte on October 08, 2009, 12:05:47 am ---Hi there ollie,

i know this is kinda off topic, but could you tell me if the RNS510 had RCA sockets for the amp leads?
cheers mate  :drinking:

--- End quote ---

Just read this post. No it doesn't. I used a Blaupunkt THA 555 Amp which uses a separate wiring loom. The normal quad-lock goes into the new wiring loom and there is a quad-lock on the new loom which goes into the back of the RNS. That is all that is required to fit it. Its really easy! :happy2:

mclovin:
You can also use a Line Output Converter (LOC) to get a line-level output, I'm making up a plug and play wiring loom right now with a LOC attached to it so I can use it with my amp and sub. I'll write it all up once I've done it and post it up here if that helps?

monte:

--- Quote from: mclovin on November 09, 2009, 07:01:44 pm ---You can also use a Line Output Converter (LOC) to get a line-level output, I'm making up a plug and play wiring loom right now with a LOC attached to it so I can use it with my amp and sub. I'll write it all up once I've done it and post it up here if that helps?

--- End quote ---

 That would be Great!....................Just like your forum name :happy2:

mclovin:
Cheers! The plug and play wiring loom I'm making will also connect up my Bluetooth kit and the MDI kit, but it can easily be built up in stages. It took me ages to dig out all the bits of info I needed, pull it together everything out and get all the right bits so I figured there was a need to put a guide together for anyone else who might want to do this.

I though I'd do it in three parts, LOC/amp connector first, then with bluetooth connection and then with the MDI but the MDI kit has some duplicate parts in it so I'm not sure if that's the right order - Either way I'll figure it out and put something together.

Navigation

[0] Message Index

[*] Previous page