General > Detailing

first time claying

<< < (2/4) > >>

robson4:
Yeah it feels rough as hell, thanks for the advise I'll look into it tonight.

robson4:
Also do you think the autoglym kit is worth a try?

Stevie35:
Never used it but it could be worth a shot, meguiars smooth surface kit is a good kit to start with.

xjay1337:
Before you clay you should always use an Iron fallout remover and a tar remover and rinse both with PLENTY of water... for Iron remover spray on and leave for a short while up to about 10 mins depends on condition it should not be left to dry on the surface.

For tar removal (I use AS tardis as it's the best and cheapest) spray it on an area leave for about 20 seconds and then wipe with a clean microfibre and then you have to rinse very thoroughly

This reduces the chances of clay bar marring but you are highly likely need to need to polish the surface afterwards despite what some people may tell you.

Pete-r:

--- Quote from: Stevie35 on April 16, 2014, 09:19:59 am ---Never used it but it could be worth a shot, meguiars smooth surface kit is a good kit to start with.

--- End quote ---

I use this clay with chemical guys lube and find it works great.

As above though I'd use a tar remover first to get the heavy stuff loose or off.

Navigation

[0] Message Index

[#] Next page

[*] Previous page