All Things Mk5 > How to Guides / Troubleshooting

Running Speaker Cable Through Door

<< < (2/3) > >>

SI-R32:
Yes there are mate,  the plug has 28 pins and uses about 10

dazza:

--- Quote from: Softishman on January 24, 2015, 08:55:39 am ---A little question... If you going to install a three-way speaker set up with all driven by it's own amp? Then I need 3 cables in, are there room for that many?

--- End quote ---
An active system  :drool:
With some careful work with the dremel you can get it done these pins next to the ones i drilled out are also free.

piston broke:
Good to know you can get three sets of speaker cables through for a full active door speaker set, what size cables did you use?

dazza:

--- Quote from: piston broke on February 03, 2015, 09:44:17 pm ---Good to know you can get three sets of speaker cables through for a full active door speaker set, what size cables did you use?

--- End quote ---
16AWG / 6.5mm * 3.2mm

Softishman:

--- Quote from: dazza on January 24, 2015, 10:05:30 am ---
--- Quote from: Softishman on January 24, 2015, 08:55:39 am ---A little question... If you going to install a three-way speaker set up with all driven by it's own amp? Then I need 3 cables in, are there room for that many?

--- End quote ---
An active system  :drool:
With some careful work with the dremel you can get it done these pins next to the ones i drilled out are also free.



--- End quote ---

An active system... The components i am using are;
Blaupunkt Phildalphia 835
Focal Polyglass 165 VR3 front
Focal Polyglass 165 VRS back
DLS Nordica 10" bass
Audison BitOne processor with DRC control
DLS A2 For tweeters front
DLS A4 for mids an bass front
DLS A2 for backdoors
DLS A6 for bass
DLS 1F kondensator for A6
DLS 0,5F kondensator for A4

Navigation

[0] Message Index

[#] Next page

[*] Previous page