General > Detailing

Engine bay clean

(1/3) > >>

Pesky jones:
I searched from some other topics, and they helped but still have a few questions.

I can't see a way of avoiding using water and APC to scrub the engine, do you just have to be careful not to use too much water in regard to electrics? There seems to be quite a bit of exposed electrical wire about the engine

bigeyd:
I put plastic over my induction and was careful around electrics

Pesky jones:
I Don't have an induction kit on mine, so I should just be carefull with the electrics I guess. Just squeeze the sponge out before I take it to the engine so it doesn't leak water as such...

lukemk5gti:
I taped up electrical parts and open valves and power hosed very carefully.

Dried immediately afterwards too.

Unless you're very comfortable doing so then don't risk it.

Sponge, APC and brush.

Pesky jones:

--- Quote from: lukemk5gti on March 31, 2015, 02:11:16 pm ---Sponge, APC and brush.

--- End quote ---

Thanks Luke, will do!

Navigation

[0] Message Index

[#] Next page