General > Product Reviews
GTI Forge TWINtake air intake - Review....
prepree:
This is the pic i pulled from the instructions today, so i hope this is the right orientation
I did the same at the front slam panel also, is that how you have yours RR?
For a £350ish product this kind of takes the pi$$ for something that should be simple, I know either orientation wont cause any harm, lack of performance but still its pretty slack!
Not sure on mine at the moment, love the noise on full chat but when in D mode im not keen on the initial noise either, sounds strange, maybe iv got a loose connection or something, hard to describe the noise but it kind of sounds metallic for a brief moment then goes into suction mode!! Im guessing that isnt right??
Blade:
--- Quote from: prepree on September 23, 2010, 10:19:19 pm ---This is the pic i pulled from the instructions today, so i hope this is the right orientation
I did the same at the front slam panel also, is that how you have yours RR?
For a £350ish product this kind of takes the pi$$ for something that should be simple, I know either orientation wont cause any harm, lack of performance but still its pretty slack!
Not sure on mine at the moment, love the noise on full chat but when in D mode im not keen on the initial noise either, sounds strange, maybe iv got a loose connection or something, hard to describe the noise but it kind of sounds metallic for a brief moment then goes into suction mode!! Im guessing that isnt right??
--- End quote ---
Thats how mine is prepree but its the wrong way round according to the diagram above?????
bacillus:
I think your pic shows the "corrected" new orientation. :confused:
big al:
On the above picture, How do you fit the second air intake metal part to the part of the car above the headlight? I have taken out the screws, but am unsure where to go from here, It looks a bit squashed to push it in between the metal and the plastic top part. (hope that makes sense)
RedRobin:
--- Quote from: big al on September 24, 2010, 01:27:29 pm ---On the above picture, How do you fit the second air intake metal part to the part of the car above the headlight? I have taken out the screws, but am unsure where to go from here, It looks a bit squashed to push it in between the metal and the plastic top part. (hope that makes sense)
--- End quote ---
....I got your PM, Al, sorry I haven't been around to answer.
JKM fitted mine but I was there. It's a tight but not difficult fit.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version