Make a donation

Recent Posts

Pages: [1] 2 3 ... 10
1
Mk5 General Area / vis hpfp for sale?
« Last post by 9MAK on Yesterday at 11:50:00 pm »
Hi, is anyone selling brand new vis hpfp internals ?
2
Mk5 General Area / Re: K03 turbo outlet diameter
« Last post by ajmludders on Yesterday at 12:45:22 pm »
Thank you that's really helpful.  :happy2:
3
Mk5 General Area / Re: Mk5 Headliner Replacement - Suggestions
« Last post by Andy on Yesterday at 10:00:44 am »
4
Mk5 General Area / Re: K03 turbo outlet diameter
« Last post by ZoliWorks on Yesterday at 07:53:36 am »
A 3 inch will be overkill for the K03 but will work if you later plan on going K04 because they use the exact same hot side downpipe mounts. Measurements are in cm.




5
Mk5 General Area / Re: Upgrade injectors for k04 turbo (fsi engine)
« Last post by Doomhand on Yesterday at 06:27:54 am »
Take a look at german ebay (eBay Kleinanzeigen). I've seen them selling packs of 4 S3 cleaned injectors for 400 euros

Thanks a lot! I will look into those.
6
Mk5 General Area / Re: Upgrade injectors for k04 turbo (fsi engine)
« Last post by ZoliWorks on Yesterday at 06:27:16 am »
Take a look at german ebay (eBay Kleinanzeigen). I've seen them selling packs of 4 S3 cleaned injectors for 400 euros
7
Mk5 General Area / Re: Mk5 Headliner Replacement - Suggestions
« Last post by ZoliWorks on Yesterday at 06:25:41 am »
This is where I'm getting mine from when I'm redoing my interior. They also have alcantara with 2 sided tape already applied to it which is much easier but I'm going for that OEM look. Don't go full black, go anthracite, it doesn't look good.

https://sekerciotokumas.com/en/product/lakost-headliner-fabric-anthracite/
8
Mk5 General Area / Mk5 Headliner Replacement - Suggestions
« Last post by g7jhp on April 18, 2024, 09:39:26 pm »
The headliner on my 5 door Mk5 (non sunroof) has separated from the foam backing and now hangs from the front centre panel, rear centre light panel and back.

I've watched the video and will probably drop the headliner, clean it off and re-glue some new fabric and reassemble.

Having measured I think circa 140cm (wide) by 200cm (length) should be fine, but may go for 300cm.

Can anyone recommend where I can get a black headliner fabric which is like OEM?

9
Aight, went with the second option. Got a $420 used K04 off of a 2.0 TFSI BWJ that the owner upgraded to a GT35xx, built the engine and is now pushing well over 600hp according to his dyno logs. Turbocharge is by no means new but for a 225k km charger is in a pretty good shape with close to no play in the compressor wheel. In case it does break later on, it's a $300-$400 repair which is still only half of what a brand new oem charger would cost (I've looked at the local prices again, they are higher than I remember). Now all I need is good weather and I can get started on putting this car together as it's currently on stands in my garage.

Will be the first turbocharger I install but luckily I have people to rely on in case I need info on anything.


10
Mk5 General Area / Upgrade injectors for k04 turbo (fsi engine)
« Last post by Doomhand on April 18, 2024, 05:46:07 pm »
I'm looking to upgrade my injectors along with the HPFP to support a k04 turbo, but it seems I'm kind of limited to what injectors I can use.

I've heard the best option is audi s3/golf R injectors with part number 06F906036F but they apparenly have very limited availability and are very expensive (around $250 usd for each).

What other options there are? I've heard that RS4 injectors have a different flow pattern and are difficult to tune. What about mk7 injectors? are they bigger? will they work?

I need to some options without spending 1k on it.

Thanks!
Pages: [1] 2 3 ... 10