MK5 Golf GTI
All Things Mk5 => How to Guides / Troubleshooting => Topic started by: GVK on August 15, 2020, 01:25:17 pm
-
Whilst fitting a rear ABS sensor I've managed (heavy handed) to snap the locking tab off the connector that goes onto the sensor :slap:
Anyone know if there is a repair loom for these, cost of and how far does it go into the car?
-
The broken piece will have a part number on it. Simple splice should do it. Like me you may need a magnifier to ID
-
You can buy new connectors from vw or on ebay and replace it by de pinning the connector, there are some videos on YouTube.
-
Found this on ECS tuning.
https://www.ecstuning.com/b-genuine-volkswagen-audi-parts/rear-abs-sensor-wiring-harness-right/1k0927904aj/
right rear 1K0927904AJ will see if it's available from VW in UK.
(https://c1552172.ssl.cf0.rackcdn.com/720072_x800.webp)
-
Replacing that section of loom is likely to be a right faff.
I would go for replacement connector as suggested by Terrier & Octoparrot
The rubber boot will peel back and you just need to remove the pins and reassemble onto the replacement connector.
Personally I would be happy with a scrap yard sourced used connector, in fact grab a couple
-
-
"h2fconnectors2016" on the bay of plenty :happy2:
-
Thanks guys. :happy2:
pn 6E0973702
Also pn 8T0973702 not sure what difference is?