Forum Donations 2024/2025
on October 25, 2024, 09:29:59 am
HI Guys The funds from the last donation effort ran out in July. The hosting cost are €22 a month. Ive created a goFundMe as the paypal pools only last one month. https://gofund.me/1bd89a45Thanks again for your support
Re: Marticus' Red GTI
Last Poster: Marticus in Members Rides on Today at 04:45:59 pm
Bit more progress today:  Finally got the rest of the front end off. Some of the bolts are too rusty to recover I think, and the front impact bar is also pretty grotty, so I'#039m thinking I will probably just replace that.
Mk5 drivers door lock issue. Ive tried everything.
Last Poster: Fckfvd in How to Guides / Troubleshooting on Yesterday at 02:56:55 pm
Hello guys, im new here. I brought a edition 30 cheap 3 years ago that needed engine work. All done, runs a dream. A month or so ago my drivers door lock stopped working. Ive been a mechanic for 10 years and this one has got me stumped. I know mk5s are notorious for door lock problems and was well aware of the normal faults. My drive door no longer locks or unlocks from
Re: Low oil pressure caused by PCV?
Last Poster: ZoliWorks in Mk5 General Area on July 11, 2025, 04:50:28 pm
Not exactly plug and play though as you have to drop the pump and drill into it, so as it says on the page, a last resort. Would be good to know the oil pressure numbers at the different RPMs before taking a decision on where to throw time and money.
[quote author=ZoliWorks link=topic=13
Re: new golf gti mk5 owner
Last Poster: matty s in Mk5 General Area on July 11, 2025, 05:50:08 am
ill be honest ive taken a two day mental health break from it for now hahaha i will defo check that first when i take a deep breath and go back in lol,
ive ordered a version of vcds in the mean time to hopefully help me down the road with other issues ( abs light ) etc nbsp ive noticed i need to re calibrate the steering wheel too after switching the power back in before f
Re: Steering Control Module
Last Poster: matty s in Mk5 General Area on July 09, 2025, 02:28:16 pm
did you cure this issue afterwards? nbsp i just replaced / repaired my ignition barrel removing broken foreign bodies and now my wipers have stopped working. nbsp i can hear the relay when i pull back on the stork for washer jet but no motor noise and the rear wiper still works but no from screen wipers at all, nbsp i did have to re fit it several times to get the indicators to start worki
Re: Cold start issues - LPFP, HPFP, Injectors replacement - Results
Last Poster: ZoliWorks in Mk5 General Area on July 03, 2025, 08:46:59 pm
I havent touched the vac pump and no ETA when I'#039ll get to it as I was busy fitting S3 brakes front and back and refreshing the turbo with an anti surge core. I'#039ve replaced the 3 plastic rings around the VVT adjuster but no difference. I have massive misfires on cyl 3 when idle. It sometimes logs 20, sometimes 80 before it reset. My camshafts look worn out, pitted and rusted so la
Brake pads - which type?
Last Poster: slipd in Mk5 General Area on June 30, 2025, 07:19:03 am
Hi guys,
Is there a way of finding out which brake pads you have? I notice on most of the part sites that there are a couple of variants. I've got a standard, 1.6 FSi BLF.
Thanks!
|
Users: 1 Guests: 510
|