MK5 Golf GTI
All Things Mk5 => Mk5 General Area => Topic started by: Max roper on November 01, 2016, 06:27:09 pm
-
Good evening everybody! Just got my kufatec loom for heated seats through. I've got the 2007 loom and seats, but got a bit confused when I received the loom and both of the seat connectors have a bridge from pin 9-8 on both passenger and drivers side. I'm a bit miffed as I've looked at my seats and they don't have pin 9 (where the wire bridges from), so wondering whether I should leave the bridge or just remove it and just use pin 8.
Any info would be golden
-Max
-
Have you seen the guide? There are some pictures of the connectors in there that may help.
I will check mine when home, but I guess if you don't have pin 9, it doesn't matter, just leave them?
Jas
-
I have check my seats, were also done with kufatec loom.
On the seat side, in both seats, pin 9 is blank.
On the kufatec loom 8 & 9 are bridged.
I just left it as it is, no problems.
Jas