MK5 Golf GTI
All Things Mk5 => Mk5 General Area => Topic started by: micaerin on June 01, 2010, 12:09:51 pm
-
Has anyone ever attempted replacing a glovebox?, or is there a how to anywhere
thanks in advance :smiley:
-
I could do with this info as well as i've got the panel that surrounds the glovebox to replace - so i can get rid of the factory car cradle thing and not leave a big hole in the dash
-
Pop out the few bits of trim around the glovebox, there should then be about 7 torx screws holding it in place, whip them out and it should pull out. There will be a couple of wire connections, one for the lighting, airbag and a small piece of pipework for the glovebox A/C that need disconnecting.
The re-build is exactly the opposite.
Luke.
-
As Snapey said but with a picture from Elsawin
Removal
– Switch off ignition.
– Remove side dash panel cover on front passenger side → Chapter.
– Release sill panel moulding from body, in area of transition to lower A-pillar moulding:
t Two-door → Chapter
t Four-door → Chapter
– Remove A-pillar lower trim on front passenger side → Chapter.
– Remove centre cover → Chapter.
– Remove the seven bolts -1-, -2- and -3- (1.5 Nm).
– Slide glove compartment outwards onto limit stop -arrow A-.
– Detach glove compartment -arrow B- from dash panel.
– Disconnect wiring harness from light and contact switch.
– If vehicle is equipped with front passenger airbag disabling, disconnect wiring harness from key switch.
– If vehicle is equipped with glove compartment cooling, disconnect air conditioning duct from glove compartment.
– If vehicle is equipped with a footwell light, disconnect wiring harness from light
(https://www.mk5golfgti.co.uk/forum/proxy.php?request=http%3A%2F%2Fimg185.imageshack.us%2Fimg185%2F4217%2Fglovebox.png&hash=72454c03b311f8503cac962bbb18d9c5e5883aa3)
-
trying to use this pic as a guide, i cant seem to find the last screw, the left 'number 3'
i think it maybe above the gear stick but cant remove the trim :sad1:
???
-
You have to prise off a plastic cover to see it, easy once you see it
-
You have to prise off a plastic cover to see it, easy once you see it
popped off cheers.
got the whole glove box out and found the culprit... a small while cog had come off its runner. sorted now and working smooooth again..
only trouble is re fitting the whole thing aarrrrgggghhhh!!