MK5 Golf GTI
All Things Mk5 => Performance Modifications => Modifications & Technical Area => Revo Zone => Topic started by: chris s on February 02, 2012, 09:01:56 pm
-
Hi, I've recently moved us to stage 2+ and had the dealer set it at b7t5f9. But as i have my own vcds i wanted to know if there is a list of blocks that should be logged before changing settings? I know of a few blocks but hoped to get advice from the more knowledgeable
-
Log:
003 for load, afm, throttle angle (think throttle angle is in ths one anyway, may be ignition angle)
020 for ignition pull
115 for requested and actual boost
230 hpfp pressure requested vs actual
You will find that the installer will have left it at optimal setting during the datalogging and apping session when it was installed, however if you do alter 1 parameter then you still need to datalog all of the others as one affects them all.
-
Sounds like a stoopid question, but is logging neccessary if lowering these settings and not increasing them? From my understanding the idea of logging is to make sure that your new higher setting are safe for the car? Or is it worth logging when either increase/decreasing SPS values?
-
Sounds like a stoopid question, but is logging neccessary if lowering these settings and not increasing them? From my understanding the idea of logging is to make sure that your new higher setting are safe for the car? Or is it worth logging when either increase/decreasing SPS values?
It shouldn't really be necessary to log if you are lowering your settings for timing and/or boost if they where optimal in the first place. Mind you logging might pick up results pointing to a unexpected problem.
-
He may be on about the fuelling, which could be seen as lowering if changing from 9 to 6 etc :stupid: