MK5 Golf GTI

All Things Mk5 => How to Guides / Troubleshooting => Topic started by: tommygti on September 09, 2012, 07:18:14 pm

Title: ITG intake fitment help?
Post by: tommygti on September 09, 2012, 07:18:14 pm

Bought an itg maxogen intake. Managed fit the system without any problems or instructions and considering I was not supplied with the whole kit it was much simpler than I thought it would be. I have how ever run into a small problem. I cant seem to remove the two lugs that the heat shield supplied with the kit fits to. Any help?

(https://www.mk5golfgti.co.uk/forum/proxy.php?request=http%3A%2F%2Fdaz.co%2Fmedia%2Fnn193%2Ffiestacossie%2Fphoto1.jpg&hash=b33e65665f0f21cf3a5d2577f5aba7c125c0e595)

Title: Re: ITG intake fitment help?
Post by: Hedge on September 09, 2012, 07:22:34 pm

If thats the back of the engine then they have non-captive nuts on the back. Don't bother to refit them.  :wink:

To turn the lugs either a socket, ring spanner or pipe/mole grips.

Title: Re: ITG intake fitment help?
Post by: bacillus on September 09, 2012, 09:57:23 pm

A Draper 38019 deep 24mm socket is what's needed...

Title: Re: Re: ITG intake fitment help?
Post by: JonnyF on September 10, 2012, 07:35:17 am

Is that the two lugs that the rubber comes off and fits into the itg bracket and then pushes over them to keep it in place?

Sent from my HTC One S using Tapatalk 2