MK5 Golf GTI

All Things Mk5 => Mk5 General Area => Topic started by: Pikey Motorsports on March 04, 2013, 12:05:29 am

Title: milltek fitment advise
Post by: Pikey Motorsports on March 04, 2013, 12:05:29 am

going to be fitting a full milltek to my ed30 this week myself..

any tips or advice?

will i need any new bolts or a new bolt to go with the new bush supplied or does milltek supply everything needed? will i need any new gaskets turbo/downpipe gasket etc or do they supply everything?

Cheers

Title: Re: milltek fitment advise
Post by: Tortaruga on March 04, 2013, 12:16:56 am

You might need oxy-acetylene.

You should fit a new gasket & bolts where it meets the turbo. For the cost it makes sense and is good practice.

I have no idea if Milltek provide these with their exhausts.

Title: Re: milltek fitment advise
Post by: Pikey Motorsports on March 04, 2013, 07:50:16 pm

cheers  :happy2:

but what would i need that for?

Title: Re: milltek fitment advise
Post by: Baz300 on March 04, 2013, 08:41:01 pm

Get a new turbo to exhaust gasket from the dealer, I would get 4 x new nuts too as they might warp when removing.

Spray the turbo to exhaust bolts with wd40 the night before and again when you go to remove them.

http://www.goapr.com/support/APR%20VW_AUDI%20TURBO%20INS5098.pdf

Title: Re: milltek fitment advise
Post by: Pikey Motorsports on March 04, 2013, 09:40:46 pm

Cheers  :happy2:

Title: Re: milltek fitment advise
Post by: Tortaruga on March 04, 2013, 10:22:17 pm

Quote from: Pikey Motorsports on March 04, 2013, 07:50:16 pm

cheers  :happy2:

but what would i need that for?

You might need to heat the area around the bolts to get them out.

Title: Re: milltek fitment advise
Post by: rich83 on March 05, 2013, 12:49:43 am

 :sick: :sick: :sick: