MK5 Golf GTI

All Things Mk5 => How to Guides / Troubleshooting => Topic started by: Jai86 on December 30, 2014, 10:10:48 am

Title: a bit of a problem vcds codes and i dont no where to start
Post by: Jai86 on December 30, 2014, 10:10:48 am
hey had a few lil problems like my car being down on power limp mode and so on just wandered if any one could shed some light on the situation

its a 58 plate golf gt tdi sport L
2.0 bkd engine


01-Engine -- Status: Malfunction 0010
03-ABS Brakes -- Status: OK 0000
04-Steering Angle -- Status: OK 0000
08-Auto HVAC -- Status: OK 0000
09-Cent. Elect. -- Status: Malfunction 0010
15-Airbags -- Status: OK 0000
16-Steering wheel -- Status: OK 0000
17-Instruments -- Status: OK 0000
19-CAN Gateway -- Status: OK 0000
25-Immobilizer -- Status: OK 0000
42-Door Elect, Driver -- Status: OK 0000
44-Steering Assist -- Status: OK 0000
46-Central Conv. -- Status: OK 0000
52-Door Elect, Pass. -- Status: OK 0000
 
-------------------------------------------------------------------------------
Address 01: Engine        Labels: 03G-906-016-BKD.lbl
   Part No SW: 03G 906 021 PP    HW: 03G 906 021 AN
   Component: R4 2,0L EDC G000SG  4661 
   Revision: --H09---    Serial number: VWX7Z0H93NA025
   Coding: 0000072
   Shop #: WSC 66565 257 00032
   VCID: 7CF184B23F9C0DFEC75-8029

3 Faults Found:
001025 - EGR System
               P0401 - 000 - Insufficient Flow
             Freeze Frame:
                    Fault Status: 01110000
                    Fault Priority: 2
                    Fault Frequency: 28
                    Reset counter: 255
                    Mileage: 169359 km
                    Time Indication: 0
                    Date: 2000.00.00
                    Time: 23:58:39

             Freeze Frame:
                    RPM: 1470 /min
                    Speed: 52.0 km/h
                    Load: 7.5 %
                    Duty Cycle: 14.6 %
                    Duty Cycle: 58.0 %
                    Mass Air / Rev.: 265.0 mg/str
                    Mass Air / Rev.: 525.0 mg/str

000833 - Camshaft Position Sensor (G40)
               P0341 - 000 - Implausible Signal - Intermittent
             Freeze Frame:
                    Fault Status: 00110000
                    Fault Priority: 3
                    Fault Frequency: 53
                    Reset counter: 255
                    Mileage: 169361 km
                    Time Indication: 0
                    Date: 2000.00.00
                    Time: 00:02:15

             Freeze Frame:
                    RPM: 1029 /min
                    Speed: 26.0 km/h
                    Load: 0.0 %
                    Voltage: 14.36 V
                    Bin. Bits: 00001000
                    Idle Stabilization: 0.0°KW
                    (no units): 48.0

005784 - Please Check DTC Memory of Steering Wheel Electronics
               P1698 - 000 -  - Intermittent
             Freeze Frame:
                    Fault Status: 00100000
                    Fault Priority: 6
                    Fault Frequency: 1
                    Reset counter: 255
                    Mileage: 169563 km
                    Time Indication: 0
                    Date: 2000.00.00
                    Time: 22:31:59

             Freeze Frame:
                    RPM: 1932 /min
                    Speed: 50.0 km/h
                    Load: 16.9 %
                    Voltage: 13.83 V
                    Bin. Bits: 11001000
                    Bin. Bits: 00000000
                    (no units): 0.0

Readiness: 1 1 0 0 0

the central electronics are just bulbs but the engine part thats a lil diff ha
just need a little bit of help from what i think is the best forum
Title: Re: a bit of a problem vcds codes and i dont no where to start
Post by: Matto on December 30, 2014, 10:34:22 am
My first port of call with any faults is the Ross-Tech Wiki site.

First one could be that the EGR is blocking up and needs a clean. They are prone for getting sh*t up.
http://wiki.ross-tech.com/wiki/index.php/16785/P0401/001025 (http://wiki.ross-tech.com/wiki/index.php/16785/P0401/001025)

http://wiki.ross-tech.com/wiki/index.php/16725/P0341/000833 (http://wiki.ross-tech.com/wiki/index.php/16725/P0341/000833)

http://wiki.ross-tech.com/wiki/index.php/18106/P1698/005784 (http://wiki.ross-tech.com/wiki/index.php/18106/P1698/005784)
Title: Re: a bit of a problem vcds codes and i dont no where to start
Post by: Jai86 on December 30, 2014, 10:46:10 am
Oh sweet iv just had a look there's a bit oil coming from the asv I guess there's a problem there
Title: Re: a bit of a problem vcds codes and i dont no where to start
Post by: Matto on December 30, 2014, 11:53:37 am
The ASV's are prone to failing also but you aren't getting the fault code for that. I took one apart a while a ago to see why it failed.

http://www.mk5golfgti.co.uk/forum/index.php/topic,75990.msg798935.html#msg798935 (http://www.mk5golfgti.co.uk/forum/index.php/topic,75990.msg798935.html#msg798935)
Title: Re: a bit of a problem vcds codes and i dont no where to start
Post by: Jai86 on December 30, 2014, 09:17:46 pm
The ASV's are prone to failing also but you aren't getting the fault code for that. I took one apart a while a ago to see why it failed.

http://www.mk5golfgti.co.uk/forum/index.php/topic,75990.msg798935.html#msg798935 (http://www.mk5golfgti.co.uk/forum/index.php/topic,75990.msg798935.html#msg798935)

mate you are a legend i just had a look at the asv and theres oil coming out of it and that code did come up before on a different machine though that could be a cause i will price that up :-D
Title: Re: a bit of a problem vcds codes and i dont no where to start
Post by: Matto on December 30, 2014, 10:33:02 pm
No worries mate. Try Euro Car parts and search the internet for a discount code. Will normally have them in stock  :happy2: