All Things Mk5 > How to Guides / Troubleshooting
New Flywheel and Clutch, can't get into gear.
r5gtt:
Progress :laugh:
Dont know how you managed to under tighten those bolts :slap:
ChazGTI:
All Sorted! Can't believe it was that.
Can't look over the basics!
Not sure how I managed to under tighten them that badly, but then again I didn't have a torque wrench that fitted the 12 point socket so I had to improvise.
Lesson learned!
Thank you all for the fantastic help and suggestions :happy2:
Dan_FR:
Great news. Hope they're tight enough now, big of thread lock is normally a good idea
xjay1337:
--- Quote from: ChazGTI on July 08, 2016, 12:31:02 pm ---Well as @Dan_FR had pointed out, I had under-tightened the PP bolts. Just finished slowly tightening them through the starter hole while a friend rotate the crank.
Tested the clutch and now the PP stays still like it should. Gonna put everything back together and HOPEFULLY all will be good.
--- End quote ---
Result!!! :-)
ChazGTI:
--- Quote from: Dan_FR on July 08, 2016, 03:31:35 pm ---Great news. Hope they're tight enough now, big of thread lock is normally a good idea
--- End quote ---
Yep used some loctite blue!
Man, the difference in a new clutch and flywheel after the state mine were in is so bloody nice!
Navigation
[0] Message Index
[*] Previous page
Go to full version