All Things Mk5 > How to Guides / Troubleshooting
How to retro fit cruise control. Comprehensive guide
kevster996:
--- Quote from: kisyov on March 21, 2019, 04:48:17 pm ---Hello friends, I need help. I have VW Caddy Maxi 2009 /same as golf mk5/, after retrofitting cruise control and MFSW , horn stop working and the buttons of SW Not working. I change my control module from mid line to highline /from 1K0-953-549-CQ to 1K0-953-549-CF /. From Ross-Tech website I saw that my Slip Ring is Type 2. I think, I did everything right, but only cruise control working, no buttons and no horn.
Parts I use.
1Q0 419 091 KUSZ – Steering Wheel / 17.11.2007 /
1K0 971 584 N – airbag harness / original harness from my not MFSW is same without N /
2k0 880 201 L 10QB - Airbag from my original SW
1k0 959 538 F – MFSW buttons
1P0 959 542 – MFSW control unit
1K0 953 549 CF – Control module
1K0 953 513 G – Cruise control stalk
Wipers stalk I didn’t change, it is with trip button.
Address 16: Steering wheel Labels: 1K0-953-549-MY9.lbl
Part No SW: 1K0 953 549 CF HW: 1K0 953 549 CF
Component: J0527 055 0111
Coding: 0000534
Shop #: WSC 01357 011 00200
VCID: 78FF0E6B0B2690DEAC3-802D
1 Fault Found:
01426 - Controls in Steering Wheel (E221)
004 - No Signal/Communication
I thought that My SLIP RING NOT working, after I put my old airbag harness from non MFSW and recoding the Control Module, horn start working and cruise control, too. So my SLIPRING is OK.
So what is wrong , where is my mistake? I want my MFSW to work. I this to change airbag harness, please suggest model.
--- End quote ---
did you fix this yet? i have similar problems on my 2005 tdi 2.0 - I need to get VCDS on it I think. I have CH module not not CF like yours and a midline display. I dont have power steering either right now since I changed the module! I have found a local guy who can have a look - he is about £60 an hour but can prob do lots in one hour... I hope I dont need a different module.
GTXcess:
Having my read this morning excellent guide, and various YouTube videos I’ve now had two goes at this with no luck and would welcome some advice.
My 2008 GTI now has the right CC stalks, I’ve coded through VCDS and can see that the stalks are registering inputs by looking at the measuring blocks. But nothing is producing lights on the dash or CC actions. The control module is the midline BC variant and as a 2008 car should have wiring installed.
Before I start buying any more parts to throw at it, any suggestions as to where I’m going wrong?
mjmallia:
I would double check there is a wire and not make the assumption, as the car might see the stalk but it is not being received by the ECU.
I sell the wire if needed, as if everything else is fitted and coded that is all :happy2:
Navigation
[0] Message Index
[*] Previous page
Go to full version