All Things Mk5 > How to Guides / Troubleshooting
Quad Rear Lights / Skyline Mod using standard inner lens (NOT Valeo)
G40will:
--- Quote from: MateyGuv on January 07, 2014, 06:24:23 pm ---
--- Quote from: G40will on January 07, 2014, 06:02:25 pm ---Thanks very much for doing the extra video mate!
I'm in two minds weather to do the quad lights mod whilst there apart :sad1: I do like the look of that mod but not sure if I can be assed to do it :popcornsoda:
--- End quote ---
It is all a bit of a pain in the bum but I like my projects and think the end result is worth it. The worst bit is separating the lenses so it would be the perfect time to do the quad mod. Up to you dude
--- End quote ---
That is a very good point! And I suppose I do need to do a bit of wiring in the boot lid after changing to a mk6 handle (wiring needs an extension)
I should just order the bits and do it!
MateyGuv:
:jumpmove: :pomppomp: Do it!!! :pomppomp: :jumpmove:
I notice the wiring is different for the MK6 handle (3pins) when I did my reverse camera, any idea why?
G40will:
Mines just a standard mk6 handle, no camera.
It had the same connector, just the location of the plug stretched the standard wiring more than I would like.
JoeDarKa:
Iv only just realised my led rings have resistors in the cabling. Were yours like this?
JoeDarKa:
Answered by own question as they are the same. Did you detach the cable from the resistor and drill a bigger hole to fit the plug through aswell or did you take the plug off completely?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version