All Things Mk5 > How to Guides / Troubleshooting

Quad Rear Lights / Skyline Mod using standard inner lens (NOT Valeo)

<< < (9/34) > >>

G40will:


This is the only pic I have of the outer completely stripped down.

It has a similar cavity to the inners...

v4rley:

--- Quote from: MateyGuv on January 27, 2014, 09:42:34 pm ---Looking good!!!  :congrats: The LED bulbs in the outers are really worth doing. I found the outers looked a little orange when compared to the LED rings I used on the inners.  

--- End quote ---

Thanks am very pleased. Where did you get your led 1156 outer bulbs on bold-sport? and I right that a full set would be approx £50?

MateyGuv:

--- Quote from: G40will on January 28, 2014, 09:19:30 am ---

This is the only pic I have of the outer completely stripped down.

It has a similar cavity to the inners...

--- End quote ---

May be possible then, not sure how you'd wire it though. Did the red lens have a divider in it or something simular cause when the brakes are on the brake light is a very defined half circle

MateyGuv:


Thanks am very pleased. Where did you get your led 1156 outer bulbs on bold-sport? and I right that a full set would be approx £50?

Here is the link - http://www.bold-sport.com/store/index.php?route=product/product&path=43_39_57&product_id=268
It was about 50, look on eBay and you will find lower cost ones. Iv always been really happy with bold sport stuff and had no errors or issues so didn't mind paying a bit over the odds for an easy life. Just to confirm you will need a total of 4 bulbs so 2 packs of them

G40will:
Yes there is a diveder in the lamps silver backing part so I guess it would be difficult to get the ring in there. Would need some cutting to be done!

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version