All Things Mk5 > How to Guides / Troubleshooting
How to change Fuel Pump Cam Follower on 2.0 TFSi
MJR:
If I'm honest, I wasn't gonna bother anyways lol but thought I'd best check others have done it without TDC and getting no problems :happy2:
Cheers :happy2:
Boothy:
I don't suppose anyone knows the torque setting for the bolt that hold the fuel pump to the engine? Gonna be doing this inn a few week and I wanna make sure I don't over tighten them.......which I have a habit of doing with my sausage fingers.
alexperkins:
10nm is general setting for bolts of that nature
Just 'tight' without over tightening :happy2:
bacillus:
On the US forums it's stated as 7.5 ft lbs...
Do not overtighten as you'll strip the threading... :scared:
Boothy:
--- Quote from: alexperkins on June 08, 2011, 10:52:19 pm ---10nm is general setting for bolts of that nature
Just 'tight' without over tightening :happy2:
--- End quote ---
--- Quote from: bacillus on June 08, 2011, 10:58:26 pm ---On the US forums it's stated as 7.5 ft lbs...
Do not overtighten as you'll strip the threading... :scared:
--- End quote ---
Cheers guys. Should I put some thread lock on too?
Can you tell I'm DIY-phobic yet? :laugh:
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version