All Things Mk5 > How to Guides / Troubleshooting

Mk6 climatronic problem

<< < (2/3) > >>

99hagued:
Thanks for the input guys just ordered one off fleebay for £30 from Poland, its a 7N0907530AK so fingers crossed it will work because I have noticed that although the ac work after a few minutes the vent stop blowing air out so think it needs setting up with vcds.

Softishman:
That problem i also had!!! To fix that you have to solder the two flaps in parrallel, this connector!

To this

Hope you can see the colours on the wires!!!
After that everything is ok!!!

99hagued:
Ok so im going to be fitting the new can gateway tomorrow and doing the wire swap. Do I need to swap on the brown (C) connector pin 7 to 10 and pin 8 to 9 ??
what about the black (B) connector do I need to swap pin 7 to 8 ?? also any tip for coding the can gateway as it came from Poland so will be lhd.

Softishman:
Do you have vcds? Check the old can gateway in vcds and take pictures of everything! Then simply change the can gateway and check the same boxes that the old one had checked.

On the black connector (picture on my last post) you move 7 and 8 to ? And ? , don't remember the numbers but you can see the wire colours! That is for parrallel connecting the two vents so air could come front mid dashboard.

Softishman:
Have you fixed the problem yet?

Navigation

[0] Message Index

[#] Next page

[*] Previous page