Guys I have heard of people fitting under compartments/ draws below drivers seat, where can I obtain the drawer set from?
Tx in advance
Dean
Parts required to fit Underseat Draws
Draws
Part Number:
- 1K0 882 602J (Right)
- 1K0 882 601J (Left)
Colour Codes
3U6 = Art Grey
31X = latte
7G8 = Pure Beige
71N = Anthracite
Glide Frame (not sure if this part is supplied with the draw or not)
Part Number
- 1K0 882 599B 9B9 (Left)
- 1K0 882 600B 9B9 (Right)
per draw
4x Screws = N 906 986 06
1x Screw = N 909 998 01
1x Bracket = 1K0 881 548A (right) & 1K0 881 547A (left)
2x Pop Rivets 4x8 = N 900 978 02
To start remove the negative from the battery
Using a 10XZN Bit undo the 4x Bolts that hold the seat down
Tilt the seat Back
Fit the correct bracket to the corresponding seat, Line the holes up and rivet it in place
Remove the Draw from the holder, by using a large screwdriver to release the retaining tab
Line up the holes with the the draw (see first pic for holes)
The single screws into the bracket
Slide the draw back in and refit the seat
Torque for Seat bolts is 40Nm
reconnect battery
Take car for a short drive to put lights out on the dash
