All Things Mk5 > Mk5 General Area
Lumbar support retrofit and heated seats retrofit on MK5 Golf Help Please
jason_rmh:
OK, think I've figured it all out now.
Darren's pin outs look to be pre 2006 type. Mine and Skards the later type.
I know what needs to go where.
Just gotta figure the correct pin positions to repair drivers seat connector then I'm ready to give it a bash.
Apologies for speaking to myself lol, but may be useful for someone reading in the future, as the thread has been helpful for me.
Once I've checked and confirmed it all, I'll post up the results.
Jas
skard:
Jason
I just took some pics of my drivers side plugs in the hope they are what you need. I didn't have to adapt any pins in regard to hooking up the Kufatec loom, it was all plug and play.
Cheers,
David
jason_rmh:
That's a big help. Thanks for taking the time to do that.
Looks like I'm all set for a wiring session ;-)
Jas
Edit: from the pic, looks like the following, can you confirm:
1 empty
2 empty
3 empty
4 blue / black (thin wire)
5 brown (thick wire)
6 empty
7 empty
8 red / black (thin wire)
9 empty
10 purple / blue (thick wire)
Ive check by loom and the colours / tickness match. Ive ordered the repair wires and connector block.
Will repait the connector next week and then get the seats wired up.... just in time for summer! LOL.
JoeDarKa:
Does anyone know what the little plug with the brown and purple wires is for? Im also trying to work out what the red / black wire in 8 is used for?
Eddie-NL:
--- Quote from: JoeDarKa on October 01, 2012, 09:47:41 pm ---Does anyone know what the little plug with the brown and purple wires is for? Im also trying to work out what the red / black wire in 8 is used for?
--- End quote ---
That is for the seat occupied sensor for the seat belt warning
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version