All Things Mk5 > How to Guides / Troubleshooting
Door & Dashboard Alumium Trim Strips....
RedRobin:
--- Quote from: jonnyc on April 16, 2009, 11:07:18 pm ---
Let me know how you get on Robin then ill give it a go haha..
Jonny
--- End quote ---
....But if you wrap them you'll be adding weight! :grin:
RedRobin:
--- Quote from: v2brett on April 16, 2009, 11:03:03 pm ---
they come off quite easy but can also bend easily, i had mine off a while back to find a rattle. dont worry if they bend though they straighten back. and i think it would be hard to lose any clips :happy2: all the clips seem lose without the strips though
--- End quote ---
....So you can pull them off without removing any door cards etc?
Any tool which is best to use as a lever?
Start in the middle? End?
[You can tell how good I am at such things!]
jonnyc:
--- Quote from: RedRobin on April 16, 2009, 11:18:36 pm ---
--- Quote from: v2brett on April 16, 2009, 11:03:03 pm ---
they come off quite easy but can also bend easily, i had mine off a while back to find a rattle. dont worry if they bend though they straighten back. and i think it would be hard to lose any clips :happy2: all the clips seem lose without the strips though
--- End quote ---
....So you can pull them off without removing any door cards etc?
Any tool which is best to use as a lever?
Start in the middle? End?
[You can tell how good I am at such things!]
--- End quote ---
I would say get something reasonably pliable to try and pry them out with, if you use something of a hard material then I can image they would crack or something.. Just depends how well they are clipped down :scared:
RedRobin:
^^^^
Sounds like a job for a nylon spatula type thingy.
jonnyc:
--- Quote from: RedRobin on April 16, 2009, 11:41:53 pm ---^^^^
Sounds like a job for a nylon spatula type thingy.
--- End quote ---
Yeah one of those thingimyjiggys..
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version