All Things Mk5 > How to Guides / Troubleshooting

Bluetooth Phone Install Problem

<< < (4/7) > >>

vRStu:
I have -

1 V+ to pin 16
2 V- to pin 12
3 Telephone ON
8 Audio LF Signal out + connected to be connected to pin 12 con 3
9 Audio LF Signal Out - connected to be connected to pin 6 con 3
10 Screening Term 31
11 Mic in +
12 Mic in -
15 K Line
16 Mute
17 CAN Hi to pin 9
18 CAN Lo to pin 10
37 Switched positive term for phone charging
39 Term 31 -ve
41 Interface to mob phone Term 30
42 Mic Out +
43 Mic out -
44 Screening Term 31
45 Audio LF Sig input +
46 Audio LF Sig Input -
47 Wakeup lead to phone bracket
49 Serial Tx comms with tele bracket +ve
50 Serial Tx comms with tele bracket -ve
51 Serial Rx comms with tele bracket +ve
52 Serial Rx comms with tele bracket -ve

StephenED30:
Thanks for all the help so far, I ended up buying this
 
http://cgi.ebay.pl/ws/eBayISAPI.dll?ViewItem&item=180605717424

as could not figure out the wiring. When I checked this to the loom I had it turned out that the existing loom only had a plug with 2 rows of connections on where the one from e-bay had 3, only 1 wire on the third row at position 41 Interface to mob phone Term 30 (may be wrong but will check later). Have now fitted the new loom into the car and have

Address 77: Telephone        Labels: 3C0-035-730.lbl
   Part No SW: 5N0 035 730 C    HW: 5N0 035 730 C
   Component: J412                8506 
   Revision: 00019000    Serial number: 0000A07751228
   Coding: 0021141
   Shop #: WSC 00152 210 91233
   VCID: 285510EAE275

1 Fault Found:
01524 - Antenna for Telephone 
            011 - Open Circuit
             Freeze Frame:
                    Fault Status: 01101011
                    Fault Priority: 3
                    Fault Frequency: 1
                    Reset counter: 233
                    Mileage: 37803 km
                    Time Indication: 0

Did some recoding and now have this

Address 77: Telephone        Labels: 3C0-035-730.lbl
   Part No SW: 5N0 035 730 C    HW: 5N0 035 730 C
   Component: J412                8506 
   Revision: 00019000    Serial number: 0000A07751228
   Coding: 0013241
   Shop #: WSC 00152 210 91233
   VCID: 285510EAE275

Still have a couple of minor problems in that when I turn the ignition on the highline display will display Telefone and I can only transfer 1 name to the car from the phone address book but it will read all the messages. And on the phone screen on the RNS510 I have preset 1 as Mobile Box and cannot seem to change it in any of the settings.

Hedge:

--- Quote from: StephenED30 on February 23, 2011, 08:01:22 pm --- And on the phone screen on the RNS510 I have preset 1 as Mobile Box and cannot seem to change it in any of the settings.


--- End quote ---

I have that on my 7P6 phone controller. I think it's a feature  :wink:

StephenED30:
Thanks for that, but can’t see the point of making it so that you cannot edit it like the rest.  :happy2:

mortygttdi:
What phone you using Steven?  the preset 1 is for the voice mail and can be preset with your chosen number by pressing setup and going into the telephone and then speed dial.

Darren

Navigation

[0] Message Index

[#] Next page

[*] Previous page